This document provides guidance on resolving Test Drive Code 1015, missing top speed, driving distance and driving time, and failure to meet TPMS tyre pressure requirements. It applies to all vehicle models.
On this page
Checks when Test Drive Code 1015 occurs
When entering the test drive, the error "There are no Test Drive items (Code: 1015)" or "Failed to read 5 times - Code 1015" occurs.
- Please restart the app when changing vehicles. When inspecting vehicles consecutively with 1 VCI, the previous vehicle's test drive cache may remain, so please close the app completely and relaunch it.
- Please check the vehicle conditions for the test drive. Please enter with the vehicle started (Engine ON / EV READY) and all doors, the boot and the bonnet closed.
- Please update to the latest app and diagnostic master DB. Please apply the latest app version and diagnostic DB updates in a Wi-Fi environment.
-
If the automatic inspection and test drive are performed on different tablets, "There are no Test Drive items" may occur due to a local DB index mismatch.
Please continue the inspection on the same tablet.
Preventing missing top speed and distance during driving
Although the vehicle has been driven at or above the specified speed, the top speed (Top Speed) is recorded as low on the results screen, or the driving distance is missing and shown as 0.
If the tablet screen turns off or battery power saving mode activates during driving, Bluetooth data collection is temporarily suspended.
- Please set the tablet's [Settings] > [Display] > [Screen timeout] to 10 min or more.
- Please disable power saving mode and register the app as exempt from battery optimisation.
Resolving missing top speed or driving time records
The test drive time is recorded as less than 1 min, or the top speed is blank.
If you do not press [Confirm] in the confirmation window when starting the test drive, the timer and top speed are not recorded.
- Please perform it again, completing all the guidance steps.
Conditions for automatic TPMS tyre pressure acquisition and reference pressure
After the test drive, the TPMS tyre pressure value is 0 (not received), or failure to meet requirements (NG) occurs at 38~39 psi.
The reference pressure is 28.0 ~ 37.0 psi.
- If not received (0 psi), the vehicle must be driven continuously at 30km/h or more for 10 min or more for TPMS sensor Wake-up.
- For excessive tyre pressure NG (38~39 psi), the permitted tyre pressure range is 28.0 ~ 37.0 psi, so please reduce the pressure of tyres inflated to high pressure for shipping to around 35 psi before completing.
Comments
0 comments
Please sign in to leave a comment.