If a vehicle equipped with a CCU or BCU enters D-CAN Force Stop mode, diagnostic communication between GENESIS Smart and the vehicle may be unavailable. Open and close a vehicle door, or switch the ignition to ON, then retry diagnostic communication.
What is 'D-CAN Force Stop'?
D-CAN Force Stop is a mode in which the CCU forcibly blocks OBD diagnostic CAN communication to prevent the vehicle battery from discharging. Diagnostic communication can be retried after opening and closing a vehicle door or switching the ignition to ON.
Contents
1. Symptoms
When D-CAN Force Stop mode is activated on a vehicle equipped with a CCU or BCU, diagnostic communication between GENESIS Smart and the vehicle is unavailable, and the following message may appear on the diagnostic tool screen.
Error: ECU Not Responding.
Caution: GENESIS Smart does not display a separate screen indicating that D-CAN Force Stop mode is active.
2. What is D-CAN Force Stop?
D-CAN Force Stop is a mode that forcibly blocks diagnostic CAN communication to prevent the vehicle battery from discharging.
D-CAN Force Stop is OBD CAN blocking logic implemented in the CCU.
3. What Conditions Activate This Mode?
D-CAN Force Stop mode is activated when both of the following conditions remain true for 10 minutes.
- The vehicle ignition is OFF.
- The driver's door is closed.
4. Diagnostic Communication Recovery Procedure
Perform either of the following actions to deactivate the mode (Method 1 or Method 2), then retry diagnostic communication.
Step 1 (Deactivation Method 1)
Open and Close a Vehicle Door
Open a vehicle door, then close it again.
Step 2 (Deactivation Method 2)
Switch the Ignition to ON
Alternatively, switch the vehicle ignition to ON.
Step 3
Retry Diagnostic Communication
After performing either of the above actions, retry diagnostic communication with the vehicle using GENESIS Smart.
5. Additional Notes
Note: There is no dedicated screen for checking whether D-CAN Force Stop mode is active. If communication with the vehicle is unavailable, perform the procedure above, then retry diagnostic communication.
Comments
0 comments
Article is closed for comments.