[Important Version Notice]
This guide (DLogger_ForceUpdater.exe) applies ONLY when Smart DLogger displays "v4.0.0.0" and "Off-line" ("Please check network connection") (versions v4.0.1.1 and below).
If you are using v4.0.4.7 (or any version above 4.0.1.1) and encounter "Fail to update Smart DLogger (Step 5/6 : Installing HWDriver)" or "HW Driver failed to update", DLogger_ForceUpdater.exe will NOT run. Instead, temporarily disable corporate data safety (DLP) & antivirus/antimalware software, disconnect the CVCI USB cable, and run Smart DLogger as Administrator ("Run as administrator"), or perform a clean reinstall following the [Smart DLogger Installation & Update Error Troubleshooting Guide].
Symptom : Can not update renewal Smart Dlogger.
If the shows program as Off-line and shows v4.0.0.0, it may not be updated itself.
Cause : In Smart DLogger v4.0.0.0, the timeout for the 'internet connection attempt' operation was set short.
Solution :
1) Please downloadt the attachment, and extract the zip file on the background.
DLogger_ForceUpdater_v1.0.0.1.zip
2) Please run DLogger_ForceUpdater.exe
3) Commnad window will pop-up, and Dlogger update will be started.
Note that if Dlogger version is higher than 4.0.1.1, this won't execute.
Then, please just run SmartDLogger program to make the program as the latest.
[END]
Comments
0 comments
Article is closed for comments.