Skip to main content
NEW New Dedicated KIA Support Portal Are you a KIA customer?
Go to KIA Support Portal →

Power-Off During HEV Automatic Inspection and Switching Back to Customer Mode

Oscar Eom
Updated

This guide applies to specific regions or vehicle models. Check the documents below first for general prerequisites.

This document provides guidance on power-off during HEV automatic inspection and switching back to customer mode before customer delivery.

Applicable Regions and Models

  • Applicable regions: North America(HMA), Europe·Australia(HME).
  • Models: MX5a HEV / MX5 HEV(Santa Fe HEV), NX4 HEV(Tucson HEV), SX2 HEV(Kona HEV).

Vehicle Power-Off During Automatic Inspection

In the latest HEVs, such as MX5a HEV(Santa Fe Hybrid), when the automatic inspection time increases due to delays in current acquisition(800~900ms per acquisition), the vehicle controller protection logic(DCAN no-signal 6 min timer) may activate, causing the vehicle power to automatically turn OFF during inspection.

Switching Back to Customer Mode Before Customer Delivery

To prevent battery discharge, a forced switch to [Shipping Mode] is performed immediately after automatic inspection is completed.

Be sure to switch back to [Customer Mode] before customer delivery.

  1. Please switch back to [Customer Mode] before customer delivery.

Comments

0 comments

Please sign in to leave a comment.